Nonlinear vibration of functionally graded circular nanoplates based on the stress-driven method

Shishesaz, Mohammad; Shariati, Mojtaba; Mosalmani, Reza

doi:10.2140/jomms.2023.18.191

Download this article
	For screen
	For printing

Recent Issues

The Journal

About the journal

Ethics and policies

Peer-review process

Submission guidelines

Submission form

Editorial board

Subscriptions

ISSN (electronic): 1559-3959

ISSN (print): 1559-3959

Author index

To appear

Other MSP journals

This article is available for purchase or by subscription. See below.

Nonlinear vibration of functionally graded circular nanoplates based on the stress-driven method

Mohammad Shishesaz, Mojtaba Shariati and Reza Mosalmani

Vol. 18 (2023), No. 2, 191–217

DOI: 10.2140/jomms.2023.18.191

Abstract

In this work, the stress-driven method (SDM) was used to investigate the axisymmetric nonlinear vibrational behavior of functionally graded circular nanoplates and the results were compared with those of strain gradient theory (SGT). The governing equations and related boundary conditions were derived using Hamilton’s principle based on the SDM and SGT. Then, the governing equations and related boundary conditions were discretized and solved using the generalized differential quadrature rule (GDQR) in conjunction with the Galerkin weighted residual method (GWRM). The results of this study have been compared and validated with the results of other studies when applicable. The effects of aspect ratio, different boundary conditions, and mode number on the overall behavior of the nanoplates were investigated. The results show that considering the small-scale effect will have a significant influence on the results. Also, the comparison of linear and nonlinear behavior confirms the importance of using nonlinear behavior. Based on the SDM and SGT results, any increase in the magnitude of the material size parameter $L$ results in a decrease in the frequency ratios in all modes for all types of boundary conditions mentioned above. The maximum decrease results from the SGT model. In addition, the differences between the SDM and SGT frequency ratios increase as the material size parameter $L$ increases. Increasing the values of the aspect ratio $h ∕ R$ increases the frequency ratios in all modes for all types of boundary conditions. This result appears to be valid for all selected values of the material size parameter $L$ . Furthermore, for any specific value of the initial condition $W_{0}$ and the material size parameter, the smallest and largest frequency ratios are related to the SGT and SDM, respectively.

PDF Access Denied

We have not been able to recognize your IP address 18.191.202.72 as that of a subscriber to this journal.
Online access to the content of recent issues is by subscription, or purchase of single articles.

Please contact your institution's librarian suggesting a subscription, for example by using our journal-recommendation form. Or, visit our subscription page for instructions on purchasing a subscription.

You may also contact us at contact@msp.org
or by using our contact form.

Or, you may purchase this single article for USD 45.00:

Keywords

size effect, nonlinear vibration, functionally graded material, circular nanoplate, nonlocal strain gradient theory

Milestones

Received: 21 April 2022

Revised: 28 August 2022

Accepted: 20 September 2022

Published: 18 April 2023

Authors

Mohammad Shishesaz
Department of Mechanical Engineering Shahid Chamran University of Ahvaz Ahvaz Iran

Mojtaba Shariati
Department of Mechanical Engineering Shahid Chamran University of Ahvaz Ahvaz Iran

Reza Mosalmani
Department of Mechanical Engineering Shahid Chamran University of Ahvaz Ahvaz Iran

Vol. 18, No. 2, 2023